Drip application

The application of the drench should be carried out on the brood-free colony in the fall/winter as a single treatment at temperatures above 4 °C.

Preparation of the ready-to-use 3.5 % (m/V) oxalic acid dihydrate sugar solution.
The container with the oxalic acid dihydrate solution is heated in a lukewarm water bath (30 - 35 °C). Remove from the water bath and open the sealed container. Weigh and add the required amount of sugar (sucrose), as used for feeding the bees:
- 222 g when using the 500 ml bottle with 230 ml concentrate
- 443 g when using the 1 liter bottle with 460 ml concentrate.

Close the bottle tightly and shake vigorously until the sugar is completely dissolved. The solution is now ready to use and should be drizzled on lukewarm.

Application
Pour the required quantity of the ready-to-use oxalic acid dihydrate sugar solution into a syringe and drizzle onto the bees in the comb galleries from above.
The recommended dose in relation to the comb area is 0.275 ml/dm². For the most commonly used hive types, this corresponds to the following quantities of ready-to-use oxalic acid dihydrate sugar solution:

A maximum of 50 ml of the ready-to-use oxalic acid dihydrate sugar solution should be used per hive.

For two-frame hives, first spray the lower frame and then the upper frame.

Spray application

The spray application should be carried out on the brood-free colony as a single treatment at temperatures above 4 °C. It is usually carried out in the fall/winter.
A treatment in spring/summer is recommended, e.g. after the introduction of a natural or artificial swarm or when forming offshoots. The treatment in spring/summer must be carried out at times of day when the bees are not flying out. This is the only way to achieve sufficient effectiveness.

Preparation of the ready-to-use 3.0 % (m/V) oxalic acid dihydrate spray solution.
Only drinking water of hardness range I (0 - 7° dH) or distilled water should be used to prepare the oxalic acid dihydrate spray solution. Add the required amount of water:
- 200 ml for the 500 ml bottle with 230 ml concentrate
- 400 ml for the 1 liter bottle with 460 ml concentrate
Close the container and shake well. The solution is now ready for use.

How to use
Use a spray bottle or similar tool to apply the ready-to-use spray solution.
The recommended dose in relation to the honeycomb area is 0.3 - 0.4 ml/dm². For the most commonly used hive types, this corresponds to the following quantities of ready-to-use oxalic acid dihydrate spray solution:

The dose should be reduced by 50 % for a comb that is only half full. Artificial swarms in clusters are sprayed with 20-25 ml of the ready-to-use solution per kg of bee mass.

A maximum of 100 ml of the ready-to-use oxalic acid dihydrate spray solution should be applied per hive.

For an exact dosage, spray 10 pump strokes into a measuring cup using the spray bottle and calculate the quantity per pump stroke. Then calculate the number of pumps required to treat one side of the comb.

The mite infestation lasts up to 3 weeks.

Honey producers should note that certain quality requirements for honey only allow a limited acidity and no taste or odor deviations. It is therefore recommended to carry out the treatment of economic colonies without attached honey chambers or to carry out the treatment after the honey harvest. Do not spray on combs that will be used for honey production in the current year.